FIRST/PREVIOUS/NEXT/LAST
These commands change the current deal no. (shown in the main user interface).
First (ctrl+arrowUp) = Lowest board no.
Previous (ctrl+arrowLeft) = Next lower board no.
Next (ctrl+arrowRight) = Next higher board no.
Last (ctrl+arrowDown) = Highest board no. in the set

SINGLE/AUTO DUPLICATION
These commands govern what is going to be duplicated.

Single duplication (Alt+S) means that the current deal will be duplicated.

Auto duplication (Alt+A) means that From board To board (according to the Settings) will be duplicated. After the highest board no. will follow the lowest.

We strongly advise you to organize the boards in the way that they are going to be duplicated (= according to the Document Settings) BEFORE you start duplicating if you use boards without the board no. sticker on the back.

Messages before start of duplication
C.f. a separate page as regards the warnings that appear when the board to be duplicated is not consistent with the settings.

Not finished
A warning will appear if you leave the Auto duplication before all boards according to the settings have been duplicated. See illustration to the right.

MESSAGES WHILE DUPLICATING
The machine will report the status during duplication...

It can also happen that it reports:
No COM port
No response (No response Sorter)
No cards fed or Poor feeding
Card already dealt
Card not recognized
Card jam
or that the duplication is completed with a
Sorting error

HANDYDUP
The HandyDup is propelled, see the video clip showing the procedure. The lamps on the HandyDup gives you the status during duplication. See further the HandyDup page

...and tell that the duplication was successful when it stops.